TL V6-3206cc 3.2L SOHC MFI (1998)
6. Hold the pawl side connector half, and press on the back of the sleeve-side connector half in the direction shown. As the two connector halves are
pressed together, the sleeve is pushed back by the pawl.
NOTE: Do not touch the sleeve.
7. When the connector halves are completely connected, the pawl is released, and the spring-loaded sleeve locks the connector.
8. Attach the connector in the holder, then install the access panel on the steering wheel lower cover.
9. Connect the positive cable first, then the negative cable to the battery.
10. After installing the airbag assembly, confirm proper system operation:
-
Turn the ignition switch ON (II); the instrument panel SRS indicator light should come on for about six seconds and then go off.
-
Confirm operation of horn buttons.
-
Confirm operation of cruise control set/resume/cancel switches.
