TL V6-3206cc 3.2L SOHC MFI (1998)
7. Attach a dial indicator to the side of the 2nd gear.
8. Measure 2nd gear axial clearance while pushing the 1st gear towards the reverse clutch assembly.
-
STANDARD: 0.05 - 0.13 mm(0.002 - 0.005 inch).
NOTE: Take measurements in at least three places and use the average as the actual clearance.
9. If the clearance is out of tolerance, remove the 45.5 x 60 mm thrust washer, and measure its thickness.
10. Select and install a new 45.5 x 60 mm thrust washer, then recheck.
11. After replacing the 45.5 x 60 mm thrust washer make sure that the clearance is within tolerance.