TL V6-3206cc 3.2L SOHC MFI (1998)
Shift Cable: Service and Repair
SHIFT CABLE
REPLACEMENT
WARNING:
-
Make sure lifts, jacks and safety stands are placed properly, and hoist brackets are attached to the correct position on the engine.
-
Apply parking brake, and block rear wheels so the vehicle will not roll off stands and fall on you while working under it.
1. Raise the front of the vehicle, and support it with safety stands.
2. Set parking brake, and block both rear wheels securely.
3. Shift the transmission into the EN position.
4. Remove the center console.
5. Shift the transmission into the [1] position.
6. Remove the self-locking nut and shift cable end collar, then remove the shift cable from the shift lever link.
7. Pull the carpet back to expose the H02S (sensor 2) connector. Disconnect the connector, then push it to outside.
NOTE: The H02S (sensor 2) connector is located under the passenger's seat.
