TL V6-3206cc 3.2L SOHC MFI (1998)
Valve Body: Service and Repair
Valve Cap Installation
-
Caps with one projected tip and one flat end are installed with the flat end toward the inside of the valve body.
-
Caps with a projected tip on each end are installed with the smaller tip toward the inside of the valve body. The small tip is a spring guide.
-
Caps with one projected tip and a hollow end are installed with the tip toward the inside of the valve body. The tip is a spring guide.
-
Caps with hollow ends are installed with the hollow end away from the inside of the valve body.
-
Caps with notched ends are installed with the notch toward the inside of the valve body.
-
Caps with flat ends and a hole through the center are installed with the smaller hole toward the inside of the valve body.