TL AWD V6-3.7L (2010)
Front Bumper: Service and Repair
Front Bumper Removal/Installation
NOTE:
-
Have an assistant help you when removing and installing the front bumper.
-
Put on gloves to protect your hands.
-
Take care not to scratch the front bumper or the body.
-
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
1. Disconnect the outside temperature sensor connector (A) from under the front bumper (B).
2. Remove these items:
-
Front bulkhead cover See: Access Cover/Service and Repair
-
Front air guide plate See: Spoilers, Flaps, and Air Dams/Air Dam/Service and Repair
-
Front strakes See: Splash Guard/Service and Repair/Front Strake Replacement
3. Remove the bolts (A, B), the screws (C), and the clips (D) securing the front bumper (E).
NOTE: To release the clips, pry up on the center pin at the notch (F).