TL AWD V6-3.7L (2010)
6. Hold up the bumper (A), and detach the harness clips (B). Disconnect the front turn signal connectors (C), the fog light connectors (D), and, if
equipped, the headlight washer tube (E). Release the projection (F) from the bulkhead (G), then remove the bumper.
7. Install the bumper in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Make sure the outside temperature sensor, the front turn signal connectors, and the fog light connectors are plugged in properly, and if
equipped, the headlight washer tube is connected properly.
-
Make sure the front bumper engages the hooks (on the upper beam and the side spacers) on each side securely.
-
Push the clips and the hooks into place securely.
