TL AWD V6-3.7L (2010)
Rear Bumper: Service and Repair
Rear Bumper Removal/Installation
Rear Bumper Removal/Installation
NOTE:
-
Have an assistant help you when removing and installing the rear bumper.
-
Put on gloves to protect your hands.
-
Take care not to scratch the rear bumper or the body.
-
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
1. Remove the screws (A, B) and the clips (C) securing the rear bumper (D).
2. Pull out the rear bumper (A) at the wheel arch areas to release it from the hooks (B) on the side spacer (C).
3. With the help of an assistant, pull out one side of the rear bumper (A) to release the hooks (B) on the rear spacer (C) as shown. Repeat this step on
the opposite side.