TL AWD V6-3.7L (2010)
Body Emblem: Service and Repair
Emblem/Sticker Replacement
NOTE: When removing the emblems/sticker, take care not to scratch the body.
1. To remove the front "A" emblem, raise the vehicle on a lift. From underneath the vehicle, remove the two screws, then remove the emblem.
2. Clean the body surfaces where emblems/sticker are applied with a shop towel dampened in isopropyl alcohol. After cleaning, keep oil, grease, and
water from getting on the surface.
3. Apply the emblems/sticker where shown. When installing the ULEV sticker on the inside surface of the left rear door quarter glass, align the
sticker with the edge of the glass mark and the edge of the black ceramic as shown, and press the sticker into place, then remove the application
tape.