TL AWD V6-3.7L (2010)
Grille: Service and Repair
Front Bulkhead Brace Cover Replacement
Front Bulkhead Brace Cover Replacement
NOTE: When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
1. Remove the front bumper See: Bumper/Front Bumper/Service and Repair.
2. Detach the clips, and release the hook (A), then remove the front bulkhead brace cover (B).
NOTE: To release the clips, pry up on the center pin at the notch (C).
3. Install the cover in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips into place securely.
