TL AWD V6-3.7L (2010)
11. Route the wire harness of a new actuator through the hole in the bracket (D).
12. Reassemble the mirror in the reverse order of removal. Apply LOCTITE to the three screws (E) and tighten to 4 Nm (0.4 kg-m, 3 lb-ft).
13. Install the gasket in the reverse order of removal.
14. Insert the mirror actuator wires into the original terminal locations as noted in step 4.
NOTE: Be careful to insert the wires correctly because the wires cannot be removed from the coupler once they are inserted.
15. Reassemble in the reverse order of disassembly.
NOTE: Be careful not to break the mirror when reinstalling it to the actuator.
16. Reinstall the mirror assembly on the door.
17. Operate the power mirror to ensure smooth operation.
