TL AWD V6-3.7L (2010)
9. Pull the rear drain valve (A) out of the body hole. Tie a string to the top end of the rear drain tube (B), then pull the drain tube down out of the
C-pillar. Leave the string in the pillar to use when reinstalling the drain tube.
10. Install the frame and the drain tube in the reverse order of removal, and note these items:
-
Before installing the frame, clear the drain tubes and the drain valves using compressed air.
-
To install a new drain tube, tie the string left in the body during drain tube removal to the top end of the new drain tube, and pull it up into the
roof.
-
Check the frame seal.
-
Clean the surface of the frame.
-
When installing the frame, first attach the rear hook into the body holes.
-
Make sure the connectors are plugged in properly.
-
When connecting the drain tubes, slide them over the frame nozzles at least 10 mm (0.39 in).
-
Install the tube clips (A) on the drain tubes (B) as shown.
