TL AWD V6-3.7L (2010)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Replacement
Front
1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
2. Remove the front wheel.
3. Release the clamp (A), then disconnect the wheel speed sensor connector (B).
4. Remove the bolts and the wheel speed sensor (C).
5. Install the wheel speed sensor in the reverse order of removal, and note these items:
-
Do not twist the sensor wires.
-
If the wheel speed sensor comes in contact with the wheel bearing, it is faulty.
-
Make sure there is no debris in the sensor mounting hole.
6. Start the engine, and make sure the ABS and the VSA indicators go off.
7. Test-drive the vehicle, and make sure the ABS and the VSA indicators do not come on.
Rear
1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
2. Remove the rear wheel.
3. Release the clamp (A), then disconnect the wheel speed sensor connector (B).
