TL AWD V6-3.7L (2010)
6. Remove the wire harness clips (B), then remove the combination switch assembly/cable reel from the steering column.
7. Remove the cable reel See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair.
8. Remove the combination light switch (A) and the wiper/washer switch (B) from the combination switch body assembly (C).
9. Install the combination switch body assembly in the reverse order of removal, and note these items:
-
Do not remove the steering angle sensor from the combination switch body assembly.
-
When installing the cable reel, set the turn signal canceling sleeve position so that the arrow points straight up See: Restraint Systems/Air Bag
Systems/Clockspring Assembly / Spiral Cable/Service and Repair.
-
Tighten the combination switch mounting screw in the proper sequence See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Steering Column Removal/Installation.
-
With SH-AWD: Do the VSA sensor neutral position memorization See: Antilock Brakes / Traction Control Systems/Testing and
Inspection/Programming and Relearning/VSA Sensor Neutral Position Memorization.