TL AWD V6-3.7L (2010)
15. Clean up any spilled engine coolant.
16. Install the engine compartment covers See: Engine/Access Cover/Service and Repair.
17. If the maintenance minder required engine coolant replacement, reset the maintenance minder See: Instrument Panel, Gauges and Warning
Indicators/Maintenance Required Lamp/Indicator/Description and Operation, and this procedure is complete. If the maintenance minder did not
require engine coolant replacement, go to step 18.
18. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
19. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview.
20. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
21. Make sure the HDS communicates with the vehicle and the engine control module (ECM)/powertrain control module (PCM). If it does not
communicate, troubleshoot the DLC circuit See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Component
Tests and General Diagnostics/DLC Circuit Troubleshooting.
22. Select GAUGES in the BODY ELECTRICAL with the HDS.
23. Select ADJUSTMENT in the GAUGES with the HDS.
24. Select MAINTENANCE MINDER in the ADJUSTMENT with the HDS.
25. Select RESET in the MAINTENANCE MINDER with the HDS.
26. Select MAINTENANCE SUB ITEM 5 RESET with the HDS.
