TL AWD V6-3.7L (2010)
24. Remove all of the old liquid gasket from the engine block end cover mating surfaces, the bolts, and the bolt holes.
25. Clean and dry the engine block end cover mating surfaces.
26. Apply a light coat of new engine oil to the lip of the crankshaft oil seal.
27. Using the driver handle, 15 x135 L and the oil seal driver attachment, 106 mm, drive in the new crankshaft oil seal until the oil seal driver
attachment bottoms on the engine block end cover.
28. Apply liquid gasket, P/N 08717-0004, 08718-0003, or 08718-0009 to the engine block mating surface of the engine block end cover and to the
inside edge of the threaded bolt holes. Install the component within 5 minutes of applying the liquid gasket.
NOTE:
-
Apply a 2.5 mm (0.098 in) diameter bead of liquid gasket along the broken line (A).
-
If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
-
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply the new liquid gasket.
29. Install the dowel pins (A), a new O-ring (B), and the engine block end cover (C) on the engine block.
NOTE:
-
Wait at least 30 minutes before filling the engine with oil.
-
Do not run the engine for at least 3 hours after installing the engine block end cover.
