TL AWD V6-3.7L (2010)
36. Install the dowel pins (B), then align the inner rotor with the crankshaft, and install the oil pump (C).
37. Clean the excess grease off the crankshaft, and check the seal for distortion.
38. Install the baffle plate (D), then install the oil strainer (E) with a new O-ring (F).
NOTE:
-
Wait at least 30 minutes before filling the engine with oil.
-
Do not run the engine for at least 3 hours after installing the oil pump.
39. Install the rocker arm oil control solenoid/oil filter assembly (A), with a new rocker arm oil control solenoid filter (B).
40. Install the oil pan See: Engine Lubrication/Oil Pan/Service and Repair/Engine Oil Pan Installation.
41. Install the timing belt drive pulley to the crankshaft:
-
J35Z6 engine See: Crankshaft Gear/Sprocket/Service and Repair