TL AWD V6-3.7L (2010)
-
J37A4 engine See: Crankshaft Gear/Sprocket/Service and Repair
42. Install the cylinder heads:
-
J35Z6 engine See: Cylinder Head Assembly/Service and Repair/Removal and Replacement/Cylinder Head Installation
-
J37A4 engine See: Cylinder Head Assembly/Service and Repair/Removal and Replacement/Cylinder Head Installation
43. M/T model: Install the flywheel See: Transmission and Drivetrain/Clutch/Clutch Disc/Service and Repair.
44. A/T model: Install drive plate See: Transmission and Drivetrain/Flex Plate/Service and Repair.
45. Install the transmission:
-
Manual transmission See: Transmission and Drivetrain/Manual Transmission/Transaxle/Service and Repair/Removal and
Replacement/Manual Transmission Installation
-
Automatic transmission See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/Automatic Transmission Installation
46. Install the engine/transmission See: Service and Repair/Engine Installation.
NOTE: When any crankshaft main or connecting rod bearing is replaced, run the engine at idle until it reaches normal operating temperature, then
continue to run it for about 15 minutes.
