TL AWD V6-3.7L (2010)
14. Apply new engine oil to the threads of the camshaft pulley mounting bolt (A). Install the back cover (B), then install the camshaft pulley (C).
15. Set the camshaft pulleys to top dead center (TDC) before bolting them onto the engine block See: Service and Repair/Removal and
Replacement/Cylinder Head Installation.
Rear
1. Loosen the locknuts and the adjusting screws.
2. Dry the camshaft oil seal housing.
3. Apply a light coat of new engine oil to the lip of the camshaft oil seal.
4. Gently tap the new camshaft oil seal (A) into the cylinder head.
1. Tap the camshaft oil seal in squarely.
2. Install the oil seal about 0.5-1.5 mm (0.02-0.06 in) below the surface of the cylinder head.
