TL AWD V6-3.7L (2010)
Valve Cover: Service and Repair
Cylinder Head Cover Removal
Cylinder Head Cover Removal
Front
1. Remove the intake manifold See: Intake Manifold/Service and Repair/Intake Manifold Removal/Installation.
2. Remove the three ignition coils from the front cylinder head See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair.
3. Disconnect the exhaust recirculation (EGR) valve connector (A) and remove the harness holder mounting bolt (B) and the harness clamp (C).
4. Remove the harness holder (D) from the bracket.
5. Remove the front cylinder head cover.
Rear
1. Remove the strut brace See: Body and Frame/Frame/Structural Brace/Service and Repair.
2. Remove the intake manifold See: Intake Manifold/Service and Repair/Intake Manifold Removal/Installation.
3. Remove the three ignition coils from the rear cylinder head See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair.
4. Remove the harness holder mounting bolts (A) and the engine ground cable (B).
