TL AWD V6-3.7L (2010)
Drive Belt Tensioner: Testing and Inspection
Drive Belt Auto-tensioner Inspection
Special Tools Required
-
Belt Tension Release Tool Snap-on YA9317 or equivalent
1. Remove the engine compartment covers See: Access Cover/Service and Repair.
2. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and make sure to turn the A/C switch OFF, then
turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
3. Check the position of the auto-tensioner indicator (A). Start the engine, then check the position again with the engine idling. If the position of the
indicator moves or fluctuates a lot, replace the auto-tensioner See: Service and Repair/Drive Belt Auto-Tensioner Replacement.
4. Check for abnormal noise from the tensioner pulley. If you hear any abnormal noise, replace the auto-tensioner pulley See: Service and
Repair/Drive Belt Auto-Tensioner Pulley Replacement.
5. Remove the drive belt See: Drive Belt/Service and Repair.
6. Move the auto-tensioner within its limit using the belt tension release tool in the direction of the rotation arrow. Check that the tensioner moves
smoothly and without any abnormal noise. If the tensioner does not move smoothly, or you hear abnormal noises, replace the auto-tensioner See:
Service and Repair/Drive Belt Auto-Tensioner Replacement.
