TL AWD V6-3.7L (2010)
NOTE: The front injector base gasket is different from the rear one. Do not mix injector base gasket types.
2. Connect the knock sensor connector (A), then install the harness holder mounting bolts (B).
3. Install the injectors See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and Repair.
4. Install the intake manifold See: Intake Manifold Removal/Installation.
5. Inspect for fuel leaks. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode (do not operate the starter) so
the fuel pump runs for about 2 seconds and pressurizes the fuel line. Repeat this operation three times, then check for fuel leakage at any point in
the fuel line.