TL AWD V6-3.7L (2010)
-
If adjustment is required, go to step 3.
-
If no adjustment is required, go to rear toe inspection/adjustment.
3. Loosen the tie-rod locknuts (A) while holding the flat surface sections (B) of the tie-rod end with a wrench, and turn both tie-rods (C) until the
front toe is within specifications.
4. After adjusting, tighten the tie-rod locknuts to the specified torque. Reposition the rack-end boot if it is twisted or displaced.
5. Go to rear toe inspection/adjustment.
Rear Toe Inspection/Adjustment
Use commercially available computerized four wheel alignment equipment to measure wheel alignment (caster, camber, toe, and turning angle). Follow
the equipment manufacturer's instructions.
1. Release the parking brake to avoid an incorrect measurement.
2. Check the toe.
-
If adjustment is required, go to step 3.
-
If no adjustment is required, go to turning angle inspection.
3. Hold the adjusting bolt (A) on the rear control arm (B), and loosen the self-locking nut (C).