TL AWD V6-3.7L (2010)
Accelerator Pedal: Service and Repair
Accelerator Pedal Module Removal and Installation
Removal
1. Remove the driver's dashboard undercover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Driver's Dashboard Undercover Removal/Installation.
2. Disconnect the APP sensor 6P connector (A).
3. Remove the two mounting nuts (B), then remove the clip (C). Using a flat-tip screwdriver (D), push the lock (E), then remove the accelerator pedal
pad (F) from the pedal stop (G).
4. Remove the accelerator pedal module.
NOTE:
-
The APP sensor is not available separately. Do not disassemble the accelerator pedal module.
-
If the pedal stop is damaged, replace it by pulling back the carpet (A), and removing the nuts (B), the bolt (C), and the pedal stop (D).