TL AWD V6-3.7L (2010)
14. After disconnecting the quick-connect fitting, check it for dirt or damage; without SH-AWD system See: Fuel Line Coupler/Service and
Repair/Fuel Line/Quick-Connect Fitting Removal, with SH-AWD system See: Fuel Line Coupler/Service and Repair/Fuel Line/Quick-Connect
Fitting Removal.
15. Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
Without the HDS
1. Remove the driver's dashboard undercover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Driver's Dashboard Undercover Removal/Installation.
2. Remove PGM-FI main relay 2 (A) from the driver's under-dash fuse/relay box.
3. Start the engine, and let it idle until it stalls.
NOTE: If any DTCs are stored, clear and ignore them.
4. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
5. Remove the fuel fill cap to relieve the pressure in the fuel tank.
6. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
7. Remove the cover (A) and the quick-connect fitting cover (B); without SH-AWD system See: Fuel Line Coupler/Service and Repair/Fuel
Line/Quick-Connect Fitting Removal, with SH-AWD system See: Fuel Line Coupler/Service and Repair/Fuel Line/Quick-Connect Fitting
Removal.