TL AWD V6-3.7L (2010)
Fuel Gauge Sender: Service and Repair
Secondary Fuel Gauge Sending Unit Removal/Installation
Secondary Fuel Gauge Sending Unit Removal/Installation
Special Tools Required
-
Fuel Sender Wrench 07AAA-S0XA100
Removal (with SH-AWD)
1. Relieve the fuel pressure See: Fuel Filter/Fuel Pressure Release/Service and Repair.
2. Remove the rear seat cushion See: Body and Frame/Seats/Service and Repair/Rear Seat Removal/Installation.
3. Remove the access panel (A) from the right side of the floor.
4. Disconnect the secondary fuel gauge sending unit 4P connector (B).
5. Using the special tool, loosen the locknut (A).
6. Remove the locknut (A), and lift up the secondary fuel gauge sending unit (B) from the fuel tank.