TL AWD V6-3.7L (2010)
15. Install the ECM/PCM in the reverse order of removal.
16. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
17. Manually input the VIN to the ECM/PCM with the HDS.
NOTE: DTC P0630 VIN Not Programmed or Mismatch may be stored because the VIN has not been programmed into the ECM/PCM; ignore it, and
continue this procedure.
18. If the READ DATA (engine oil life) failed in step 7, go to step 21 (A/T) or step 24 (M/T). Otherwise, go to step 19.
19. Select the PGM-FI system with the HDS.
20. Select the REPLACE PCM MENU, then select WRITE DATA, and follow the screen prompts.
NOTE: If the WRITE DATA indicates FAILED, continue with this procedure.
21. A/T: If the READ DATA (ATF life) failed in step 9, go to step 24. Otherwise go to step 22.
22. A/T: Select the A/T SYSTEM with the HDS.
23. A/T: Select the REPLACE TCM/PCM MENU, then select WRITE DATA, and follow the screen prompts.
NOTE: If the WRITE DATA indicates FAILED, continue with this procedure.
24. Select IMMOBI system (without keyless access) or ONE PUSH START system (with keyless access) with the HDS.
25. Enter the immobilizer ECM/PCM code that you got from the iN, and use the ECM/PCM replacement procedure in the IMMOBI Menu (without
keyless access) or ONE PUSH START Menu (with keyless access) of the HDS; it allows you to start the engine.
26. If the TP POSITION CHECK failed in step 6clean the throttle body See: Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Procedures, then go to step 27.
27. If the READ DATA failed in step 7 or the WRITE DATA failed in step 20, replace the engine oil See: Engine, Cooling and
Exhaust/Engine/Engine Lubrication/Engine Oil/Service and Repair and engine oil filter See: Engine, Cooling and Exhaust/Engine/Engine
Lubrication/Oil Filter/Service and Repair, then go to step 28 (A/T) or step 29 (M/T).
28. If the READ DATA failed in step 9 or the WRITE DATA failed in step 23, replace the ATF See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Service and Repair/Removal and Replacement/ATF Replacement, then go to step 29.
29. Select PGM-FI system, and reset the ECM/PCM with the HDS.
30. Update the ECM/PCM if it does not have the latest software See: Computers and Control Systems/Testing and Inspection/Programming and
Relearning/ECM/PCM Update.
31. Do the ECM/PCM idle learn procedure See: Computers and Control Systems/Testing and Inspection/Programming and Relearning/ECM/PCM
Idle Learn Procedure.
