TL AWD V6-3.7L (2010)
Power Mirror Control Module: Service and Repair
Power Mirror Control Unit Input Test/Replacement
NOTE: Before troubleshooting the DPMS, troubleshoot the multiplex integrated control system first using B-CAN System Diagnosis Test Mode A See:
Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Component Tests and General
Diagnostics/Troubleshooting - B-CAN System Diagnosis Test Mode A.
1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
2. Remove the driver's door panel See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Front
Door Panel Removal/Installation.
3. Disconnect the 24P connector (A) from the power mirror control unit (B).
4. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 5.
5. Reconnect the connector to the power mirror control unit, and do these input tests at the following connector.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 6.
