TL AWD V6-3.7L (2010)
5. Install the left and right heater joint ducts (A, B), then install the clips (C).
6. Install the center heater joint duct (D).
7. Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
8. Make sure the SRS unit has the latest software. If it does not have the latest, update the software in the SRS unit See: Testing and
Inspection/Programming and Relearning/SRS Unit Update.
9. Do the ODS unit initialization See: Testing and Inspection/Programming and Relearning/ODS Unit Initialization.
10. Check the operation of the ODS unit with the HDS See: Testing and Inspection/Component Tests and General Diagnostics/ODS Unit Operation
Check.
11. Confirm proper SRS operation: Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode; the SRS indicator
should come on for about 6 seconds and then go off.
12. Reinstall all removed parts.
