TL AWD V6-3.7L (2010)
8. Install the steering wheel bolt (A), and tighten it to the specified torque, then connect the cable reel subharness 20P connector (B).
9. Install the driver's airbag See: Air Bag/Service and Repair/Removal and Replacement/Driver's Airbag Replacement.
10. Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
11. Clear any DTCs with the HDS See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
12. After installing the cable reel, confirm proper system operation:
-
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode; the SRS indicator should come on for about 6
seconds and then go off.
-
After the SRS indicator has turned off, turn the steering wheel fully left and right to confirm the SRS indicator does not come on.
-
Make sure the horn and turn signal switches work properly.
-
Make sure the steering wheel switches work properly.