TL AWD V6-3.7L (2010)
-
Inspect the cable reel for heat damage. If there is any damage, replace the cable reel.
After the vehicle is completely repaired, turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode. If the SRS
indicator comes on for about 6 seconds and then goes off, the SRS is OK. If the indicator does not function properly, use the HDS to read the DTC See:
Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes. If you cannot retrieve a code, do the SRS Symptom
Troubleshooting.
Checking and Adjusting the Headliner/Pillar Trim Overlap
To prevent the side curtain airbag from deploying and damaging the pillar trim, the overlap between the headliner and pillar trim must be less then 8 mm
(0.3 in). To check the overlap, do this:
1. Install the headliner (A) and the pillar trim (B).
2. Apply masking tape to the headliner to mark the upper edge of each pillar trim.
3. Remove the pillar trim, and measure the headliner overlap.
-
If the overlap is less than 8 mm (0.3 in), remove the tape, and install the pillar trim.
-
If the overlap is more than 8 mm (0.3 in), go to step 4.