TL AWD V6-3.7L (2010)
Seat Belt Tensioner
8. Remove the B-pillar lower trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Interior Trim Removal/Installation
- Pillar Areas, then disconnect both SRS floor wire harness 4P connectors (A) from the seat belt tensioner 4P connectors. Pull the seat belt out all
the way and cut it.
9. Cut off each connector, and strip the ends of the wires. Twist each pair of unlike colored wires together, and clip an alligator clip (A) from the
deployment tool to each pair.
NOTE:
-
Place the deployment tool at least 30 ft (10 m) away from the vehicle.
-
The driver's and front passenger's airbags have dual inflators. Twist each pair of unlike colored wires together, and clip an alligator clip to each
pair.
