TL AWD V6-3.7L (2010)
Integrated Accessory Switch Assembly: Service and Repair
Dashboard Driver's Switch Panel Removal/Installation
Special Tools Required
-
KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program
NOTE:
-
Take care not to scratch the trim or the panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
1. Remove the driver's switch panel (A).
1. Apply protective tape (B) to the dashboard under the edge of the panel.
2. Pry up on the edge of the panel with a flat-tipped screwdriver to release the hooks (C).
3. Disconnect the VSA OFF switch connector (D) and the headlight washer connector (E) (for some models).
2. Install the panel in the reverse order of removal, and note these items:
-
Make sure each connector is plugged in properly.
-
Push the hooks into place securely.
