TL AWD V6-3.7L (2010)
Ignition Switch: Testing and Inspection
Ignition Switch Test (Without Keyless Access System)
Ignition Switch Test
NOTE: SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations, precautions
and procedures See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair
before doing repairs or servicing.
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
2. Remove the steering column covers See: Steering and Suspension/Steering/Steering Column/Steering Column Cover/Service and Repair.
3. Disconnect the 5P connector (A) from the ignition switch (B).
4. Check for continuity between the terminals in each switch position according to the table.
5. If the continuity is not as specified, replace the ignition switch See: Service and Repair.
6. Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
