TL AWD V6-3.7L (2010)
Impact Sensor: Service and Repair
Front Impact Sensor Replacement
Front Impact Sensor Replacement
Removal
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, then wait at least 3 minutes
before starting work.
2. Remove the front bumper See: Body and Frame/Bumper/Front Bumper/Service and Repair.
3. Left side; remove the bolts (A), then release the intake air resonator (B).
4. Disconnect the left or right engine compartment wire harness 2P connector (A) from the front impact sensor (B).
5. Remove the TORX bolts (C) using a TORX T30 bit, then remove the front impact sensor.
Installation
1. Install the front impact sensor (A) with new TORX bolts (B) using a TORX T30 bit. Connect the left or right engine compartment wire harness 2P
connector (C) to the front impact sensor.