TL AWD V6-3.7L (2010)
6. Remove the harness clamp (C) from its bracket (D).
7. Remove the ATF temperature sensor (E), and replace the sensor.
8. Install a new O-ring (F) on a new ATF temperature sensor, and install the ATF temperature sensor.
9. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely, and install it on its bracket.
10. Install the harness clamp on its bracket.
11. Refill the transmission with ATF See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/ATF Replacement.
12. Install the splash shield.
