TL AWD V6-3.7L (2010)
19. Hold the overrunning clutch (A), and turn the drive gear (B) in the direction shown to make sure it turns freely. Also make sure the drive gear
locks in the opposite direction. If it does not lock, replace the overrunning clutch assembly.
20. If the starter drive gear is worn or damaged, replace the overrunning clutch assembly; the gear is not available separately.
Check the condition of the torque converter ring gear. Replace it if the starter drive gear teeth are damaged.
Starter Reassembly
21. Pry back each brush spring with a screwdriver, then position the brush on the brush holder about halfway out of its holder. Release the spring to
hold it in place.
NOTE: To seat the new brushes. Slip a strip of #500 or #600 sandpaper, with the grit side up, between the commutator and the each brush, and
smoothly turn the armature. The contact surface of the brushes will be sanded to the same contour as the commutator.
