TL AWD V6-3.7L (2010)
-
Ball Joint Thread Protector, 10 mm 07AAF-SECA120
-
Hub Dis/Assembly Pin, 42mm 07GAF-SD4A100
-
Attachment, 72 x 75 mm 07746-0010600
-
Driver Handle, 15 x 135L 07749-0010000
-
Oil Seal Driver Attachment, 96 mm 07ZAD-PNA0100
-
Support Base 07965-SD90100
NOTE: Refer to the Exploded View as needed during the following procedure.
Knuckle/Hub Replacement
1. Raise and support the vehicle See: Wheels and Tires/Vehicle Lifting/Service and Repair.
2. Remove the wheel nuts and the front wheel.
3. Remove the brake hose bracket mounting bolt (A).
4. Remove the brake caliper bracket mounting bolts (B), then remove the caliper assembly (C) from the knuckle. To prevent damage to the caliper
assembly or the brake hose, use a short piece of wire to hang the caliper assembly from the undercarriage. Do not twist the brake hose excessively.
5. Remove the wheel speed sensor harness bracket (A) and the wheel speed sensor (B) from the knuckle. Do not disconnect the wheel speed sensor
