TL AWD V6-3.7L (2010)
Rear Knuckle Alignment Link: Service and Repair
Rear Knuckle/Hub Bearing Unit Replacement
Exploded View
Special Tools Required
-
Ball Joint Thread Protector, 14 mm 07AAE-SJAA100
-
Ball Joint Remover, 32 mm 07MAC-SL0A102
NOTE: Refer to the Exploded View as needed during the following procedure.
Hub Bearing Unit Replacement
1. Raise and support the vehicle See: Wheels and Tires/Vehicle Lifting/Service and Repair.
2. Remove the wheel nuts, and the rear wheel.
