TL AWD V6-3.7L (2010)
Stabilizer Link: Service and Repair
Front Stabilizer Link Removal/Installation
Front Stabilizer Link Removal/Installation
1. Raise and support the vehicle See: Wheels and Tires/Vehicle Lifting/Service and Repair.
2. Remove the front wheel.
3. Remove the flange nuts (A) while holding the respective joint pin (B) with a hex wrench (C), then remove the stabilizer link (D).
4. Install the stabilizer link on the stabilizer bar (E) and the lower arm (F) with the joint pins set at the center of their range of movement.
NOTE: The stabilizer link has a paint mark (G). The left stabilizer link is marked with yellow paint, and the right stabilizer link is marked with white
paint.
5. Install the new flange nuts, and tighten them to the specified torque while holding the respective joint pin with a hex wrench.
6. Clean the mating surfaces of the brake disc and the inside of the wheel, then install the front wheel.