TL AWD V6-3.7L (2010)
8. Remove the bolt securing the harness cover (E), and remove the harness cover from its bracket (F).
9. Remove A/T clutch pressure control solenoid valves A and B, the ATF pipes (C), the gasket (D), and the O-rings (E).
10. Clean the mounting surfaces and the fluid passage of the solenoid valve cover.
11. Install a new gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing. Install new O-rings over
the ATF pipes.
12. Install A/T clutch pressure control solenoid valves A and B.
13. Install the harness cover on its bracket, and secure it with the bolt.
14. Check the connectors for rust, dirt, or oil, and clean or repair if necessary, then connect the connectors securely.
15. Apply molybdenum grease to the hole in the bushing in the shift cable end. Attach the shift cable end to the selector control lever, then insert the
control pin into the selector control lever hole through the shift cable end, and secure the control pin with the spring clip.
