TL AWD V6-3.7L (2010)
16. Remove A/T clutch pressure control solenoid valves A and B, the ATF pipes (C), the gasket (D), and the O-rings (E).
17. Check the fluid passage of the solenoid valve for contamination.
18. Connect a jumper wire from the negative battery terminal to A/T clutch pressure control solenoid valve A or B connector terminal No. 2, and
connect another jumper wire from the positive battery terminal to connector terminal No. 1. Make sure A/T clutch pressure control solenoid
valve A or B moves.
19. Disconnect one of the jumper wires, and check valve movement at the fluid passage in the valve body mounting surface. If the valve binds or
moves sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valves A and B.
20. Clean the mounting surface and fluid passage of the solenoid valve body and the solenoid valve cover.
21. Install a new gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing. Install new O-rings over
the ATF pipes.
22. Install A/T clutch pressure control solenoid valves A and B.