TL AWD V6-3.7L (2010)
Transmission Position Switch/Sensor: Testing and Inspection
Transmission Range Switch Test
1. Do the battery removal procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
2. Remove the air cleaner housing See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service
and Repair.
3. Remove the battery base See: Service and Repair/Removal and Replacement/Automatic Transmission Removal.
4. Disconnect the transmission range switch connector.
5. Check for continuity between terminals at the transmission range switch connector. There should be continuity between the terminals in the
following table for each switch position.
6. Transmission range switch test is finished if the test results are OK. If there is no continuity between any terminals, check that the transmission
range switch installation. If the switch installation is OK, replace the switch See: Service and Repair.
7. Check the connectors for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
8. Install the battery base See: Service and Repair/Removal and Replacement/Automatic Transmission Installation.
9. Install the air cleaner housing See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service
and Repair.
10. Do the battery installation procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.