TL AWD V6-3.7L (2010)
22. Install new O-rings (two O-rings per shift solenoid valve) (E) on the reused shift solenoid valves.
NOTE: A new shift solenoid valve comes with new O-rings. If you install a new shift solenoid valve, use the O-rings provided with it.
23. If shift solenoid valve D was replacement, install shift solenoid valve D (black connector) by holding the shift solenoid valve body; make sure the
mounting bracket contacts the accumulator body.
NOTE: Do not hold the solenoid valve by the connector when installing the solenoid valve. Be sure to hold the solenoid valve body.
24. If shift solenoid valve A was replacement, install shift solenoid valve A (black connector) by holding the shift solenoid valve body; make sure the
mounting bracket contacts the accumulator body.
25. If shift solenoid valve C was replacement, install shift solenoid valve C (brown connector) by holding the shift solenoid valve body; make sure the
mounting bracket contacts the bracket of shift solenoid valve A.
NOTE: Do not install shift solenoid valve C before installing shift solenoid valve A. If shift solenoid valve C is installed before installing shift solenoid
valve A, it may damage the hydraulic control system.
26. If shift solenoid valve B was replacement, install shift solenoid valve B (brown connector) by holding the shift solenoid valve body; make sure the
mounting bracket contacts the accumulator body.
27. Install the shift solenoid valve mounting bolts.
28. Connect the shift solenoid valve connector to the solenoid valve:
-
YEL wire connector to shift solenoid valve A.
-
RED wire connector to shift solenoid valve B.
-
GRN wire connector to shift solenoid valve C.
-
ORN wire connector to shift solenoid valve D.
29. Install the shift solenoid valve cover, the dowel pins, and a new gasket.
30. Install a new gasket on the solenoid valve cover, and install the ATF pipes with their filter side into the transmission housing. Install new O-rings
over the ATF pipes.
31. Install A/T clutch pressure control solenoid valves A and B.
32. Install the harness cover on its bracket, and secure it with the bolt.
33. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely.
34. Apply molybdenum grease to the hole in the bushing in the shift cable end. Attach the shift cable end to the selector control lever, then insert the
control pin into the selector control lever hole through the shift cable end, and secure the control pin with the spring clip.
