TL AWD V6-3.7L (2010)
6. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
7. Place the shift lever in R, then insert a 6.0 mm (0.24 in) pin (A) into the positioning hole (B) on the shift lever positioning guide, and into the
positioning hole on the shift lever bracket. Use only a 6.0 mm (0.24 in) pin with no burrs.
8. Align the shift cable slot (A) between the socket holder (B) and the socket holder retainer (C) with the opening (D) in the shift cable bracket (E),
then slide the holder into the bracket while installing the shift cable end (F) over the mounting stud (G) by aligning its square hole with the square
fitting (H) at the bottom of the stud. Do not install the shift cable by holding the shift cable guide (I).
NOTE: When the socket holder is installed in the shift cable bracket, the retainer lock is unhinged and releases the holder retainer lock, then the holder
retainer returns under spring force to secure the shift cable.
