TL AWD V6-3.7L (2010)
Shifter A/T: Testing and Inspection
Paddle Shifter + (Upshift Switch) Illumination Circuit Troubleshooting
Paddle Shifter + (Upshift Switch) Illumination Circuit Troubleshooting
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair in
the SRS before doing repair or service.
1. Remove the steering wheel See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Removal and Replacement/Steering Wheel
Removal.
2. Check for continuity between cable reel subharness 20P connector terminals No. 18 and No. 19.
Is there continuity?
YES -
Go to step 3.
NO -
Go to step 10.
3. Remove the cable reel See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair.
4. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and turn the lighting switch ON.
5. Measure the voltage between cable reel 20P connector terminals No. 18 and No. 19.
