TL AWD V6-3.7L (2010)
Valve Body: Service and Repair
Valve Body Repair
Valve Body Repair
NOTE: This repair is only necessary if one or more of the valves in a valve body do not slide smoothly in their bores. Use this procedure to free the
valves.
1. Soak a sheet of #600 abrasive paper in ATF for about 30 minutes.
2. Carefully tap the valve body so the sticking valve drops out of its bore. It may be necessary to use a small screwdriver to pry the valve free. Be
careful not to scratch the bore with the screwdriver.
3. Inspect the valve for any scuff marks. Use the ATF-soaked #600 abrasive paper to polish off any burrs that are on the valve, then wash the valve in
solvent and dry it with compressed air.
4. Roll up half of the ATF-soaked #600 abrasive paper and insert it in the valve bore of the sticking valve. Twist the paper slightly, so that it unrolls
and fits into the bore tightly, then polish the bore by twisting the paper as you push it in and out.
NOTE: The valve body is aluminum and does not require much polishing to remove any burrs.
5. Remove the #600 abrasive paper. Thoroughly wash the entire valve body in solvent, then dry it with compressed air.
6. Coat the valve with ATF, then drop it into its bore. It should drop to the bottom of the bore under its own weight. If not, repeat steps 4 and 5, then
retest. If the valve still sticks, replace the valve body.
