TL AWD V6-3.7L (2010)
4. Apply a light coat of super high temp urea grease (P/N 08798-9002) to the pushrod (B) of the slave cylinder.
5. Connect the clutch line (C) to the slave cylinder (D), and tighten the flare nut (E).
NOTE: Tighten the flare nut while holding the clutch line connector (F) using a wrench.
6. Install the slave cylinder and the clutch line bracket (G).
7. Bleed the clutch hydraulic system See: Service and Repair.
8. Check the clutch operation, and check for leaks.
9. Test-drive the vehicle.
O-ring Replacement
1. Remove the slave cylinder.
2. Remove the roll pins (A), then remove the clutch line connector (B) and the O-ring (C) from the slave cylinder (D).