TL AWD V6-3.7L (2010)
Clutch Release Bearing: Service and Repair
Clutch Replacement
Special Tools Required
-
Clutch Alignment Disc 07JAF-PM7011A
-
Ring Gear Holder 07LAB-PV00100
-
Clutch Alignment Tool Set 07PAF-0020000
-
Clutch Alignment Pilot, 20 mm 07PAF-0020360
-
Clutch Alignment Shaft 07ZAF-PR8A100
-
Attachment, 22 x 24 mm 07746-0010800
-
Driver Handle, 15 x 135L 07749-0010000
-
Remover Handle 07936-3710100
-
Bearing Remover Shaft Set, 20 mm 07936-3710600
-
Slide Hammer 07936-371020A
Engine Side
Pressure Plate Inspection and Removal
1. Remove the transmission See: Manual Transmission/Transaxle/Service and Repair/Removal and Replacement/Manual Transmission Removal.
2. Check the evenness of the height of the diaphragm spring fingers using the clutch alignment disc (A), the clutch alignment shaft (B), the remover
handle (C), and a feeler gauge (D). If the height difference is more than the service limit, replace the pressure plate.
3. Install the ring gear holder (A), the clutch alignment tool set (B), and the 20 mm clutch alignment pilot (C).