TL AWD V6-3.7L (2010)
NOTE: Refer to the Exploded View, as needed, during this procedure.
1. Clean the disassembled parts with solvent, and dry them with compressed air.
NOTE: Do not wash the rubber parts with solvent.
2. Press a new intermediate shaft bearing (A) into the bearing support (B) using the 15 x 135L driver handle (C), the 52 x 55 mm attachment (D),
the support base attachment (E), the support base (F), and a press.
3. Install the internal snap ring (A) into the groove (B) of the bearing support.
4. Press the intermediate shaft (A) into the shaft bearing (B) using the 39.2 x 49.5 x 15 mm fork seal driver (C) and a press.
