TL AWD V6-3.7L (2010)
Axle Shaft Assembly: Overhaul
Rear Driveshaft Disassembly
Rear Driveshaft Disassembly
Special Tools Required
-
Threaded Adapter, 24 x 1.5 mm 07XAC-001020A
-
Slide Hammer 5/8''-18 UNF, commercially available
-
Boot Band Pliers, commercially available
-
Bearing Puller, commercially available
Inboard Joint Side
1. Remove the boot bands. Be careful not to damage the boot.
-
If the boot band is a low profile type (A), pinch the boot band using commercially available boot band pliers (B).
-
If the boot band is a double loop type (C), lift up the band end (D), then push it into the clip (E).
2. Remove the circlip (A).